Like the command line, polyline command is also often used to draw lines, but between the line and polyline have a difference of principle. In line, the segment between two points (vertices) is an entity while the polyline, the entire line consists of only one entity (the whole object into a single unit
Command: pline
Specify start point:
Current line-width is 0.0000
Specify next point or [Arc / Halfwidth / Length / Undo / Width]:
or
Command: pl
Specify start point:
Current line-width is 0.0000
Specify next point or [Arc / Halfwidth / Length / Undo / Width]:
Command: pline
Specify start point:
Current line-width is 0.0000
Specify next point or [Arc / Halfwidth / Length / Undo / Width]:
or
Command: pl
Specify start point:
Current line-width is 0.0000
Specify next point or [Arc / Halfwidth / Length / Undo / Width]:
No comments:
Post a Comment