Region command serves to establish the extents of a closed wake. A wake is said closed if its initial point to meet with the endpoint. Remember, the Region is not the surface. Therefore, face modification orders cannot be applied to objects that are orders Region.
AutoCAD Region Command |
Region over the indicator, where you can obtain the physical parameters (such as gravity, area andperimeter) of the object.
Command: region
Select objects: Specify opposite corner: 4 found
Select objects:
1 loop extracted.
1 Region created.
To run your region command can perform the following steps:
- At the command line type in the region or select an icon on the toolbar region draw
- Later select a closed object that will be the object region, and then press enter.
No comments:
Post a Comment